DSC WS4904P Wireless Pet-Immune Passive Infrared Detector
-
MPN: WS4904P
-
JMAC ID: 200089902
The DSC WS4904P is a 433 MHz wireless passive infrared (PIR) motion detector designed for residential and commercial intrusion alarm systems. Featuring pet immunity up to 60 lbs (27 kg), a 40 x 40 ft detection area, and patented Multi-Level Signal Processing (MLSP), it detects human movement while reducing nuisance alarms caused by pets and environmental conditions. The detector uses one included 3V CR123A lithium battery with a typical operating life of up to 9 years and communicates with compatible DSC wireless receivers.
DSC WS4904P 433 MHz Wireless Pet-Immune PIR Motion Detector
The DSC WS4904P Wireless Pet-Immune Passive Infrared Motion Detector provides indoor motion detection for compatible DSC intrusion alarm systems using 433 MHz wireless communication. Based on DSC's Bravo 3D hardwired motion detector platform, the WS4904P uses digital signal analysis and patented Multi-Level Signal Processing (MLSP) to identify human infrared energy while reducing unwanted alarms caused by temperature changes, air movement, and other environmental disturbances. The detector covers an area of approximately 40 x 40 ft (12 x 12 m) and supports pet immunity for single or multiple animals with a combined weight of up to 60 lbs (27 kg) when installed according to manufacturer guidelines. Its wireless design eliminates the need for dedicated signal wiring between the detector and compatible alarm receiver.
The WS4904P operates using one 3V CR123A lithium battery, included with the detector, and provides a manufacturer-rated typical battery life of up to 9 years under specified operating conditions. Its integrated printed circuit board (PCB) antenna supports consistent wireless signal transmission, while temperature compensation adjusts detection characteristics as ambient conditions change. The detector incorporates high-traffic shutdown, which suspends additional motion transmissions for approximately 3 minutes following an activation to conserve battery power. Adjustable sensitivity settings allow installers to select Fast or Slow detection response based on environmental conditions and pet activity. The white enclosure measures approximately 4.25 inches high, 2.5 inches wide, and 2.13 inches deep (108 x 63.5 x 54 mm), with an operating temperature range of 14 F to 131 F (-10 C to 55 C) under the specified Fast setting.
The DSC WS4904P is compatible with supported DSC PowerSeries and MAXSYS wireless security systems using designated 433 MHz receivers, including RF5132-433, PC5132-433, RF5108-433, PC4164-433, and compatible RFK Series keypads with integrated wireless receivers. It also supports specified DSC self-contained wireless security systems, including the NT9005 Envoy. The detector installs on an interior wall or in a corner at a mounting height between 6.5 and 10 ft (1.95 to 3 m), with approximately 7.5 ft (2.3 m) recommended for typical installations. For reliable pet immunity, installers must account for furniture, stairs, elevated surfaces, and animal movement within the detection zone. DSC recommends using the Slow sensitivity setting when pets exceed 30 lbs in combined weight or when installation conditions require reduced sensitivity. A wireless placement test and walk test verify receiver communication and motion coverage before the detector enters normal operation.
The DSC WS4904P wireless motion sensor is designed for indoor intrusion detection in homes, offices, retail spaces, and other properties where pets may occupy protected areas. Its combination of 60 lb pet immunity, temperature compensation, adjustable sensitivity, and digital infrared signal processing helps maintain motion detection while limiting nuisance alarms when the installation follows DSC's placement requirements. The WS4904P is the manufacturer-designated replacement for the earlier DSC WLS904PL-433 wireless motion detector, providing an upgrade path for compatible legacy security systems. The detector is listed under applicable UL/ULC requirements for North American burglary alarm applications and complies with relevant FCC and Industry Canada radio requirements. Compatibility with the installed receiver, control panel, and wireless operating frequency must be confirmed before installation, as the WS4904P uses DSC's legacy 433 MHz wireless protocol rather than PowerG communication.
UPC: 820043000146
Also known as: 3W-WS4904P, DSC-WS4904P
Technical Specifications:
|
For more information about the DSC WS4904P, please contact us.
- High-traffic shutdown
- 1 lithium battery included
- WS4904P features pet immunity up to 60 lb (27 kg)
- Based on the Bravo® 3D hardwire motion detector
- WS4904P replaces the WLS904PL-433
2 Reviews
-
TYCO-DSC-WS4904P
-
TYCO-DSC-WS4904P