Knowledge Base:  

How many wireless devices can the Honeywell 5881ENH wireless receiver support?


Last Updated: 11/06/2013
The 5881ENH can support an unlimited number of wireless devices...


Which means the only limitation you need to pay attention to is the number of zones your Vista Series Control Panel can support.  However, medium and lower receivers, like the 5881ENM and 5881ENL, can support a total of 16 and 8 wireless devices respectively.  Below you will find a list of control panels and the total number of wireless zones they support.

Vista 10P:  16  


Similar Products:


Was this article helpful?

Comments:
 

Related Articles
 >

Where Do I Find my VISTA 20P Panel Revision?


 >

What Honeywell Glass Break Detectors Work with the Vista-20p?


 >

How Do I Program a Vista-20P Duress Code?


 >

How does the Vista 20P compare to the Vista 20PSIA?


 >

Can I add sirens to the Vista 20P? And if so, how many?


 >

How do I install the Honeywell GSMV4G and get it to work with my Vista 20P Control Panel?


 >

How do I run a GO/NO GO test on my Vista 20P?


 >

What are the device addresses for my Vista 20P?


 >

Can I use Compass Software to program my Vista 20P Control Panel?


 >

How many wireless transmitters will work with the Vista 20P?


 >

How do I connect power to the Vista 20P?


 >

How many keypads can I install with my Vista 20P?


 >

How many events can be stored in the Vista 20P event log?


 >

What is a security "event" on my Vista 20P?


 >

How does a Tuxedo Touchscreen Keypad work with my Vista 20P?


 >

How do I change the Partition 2 code for my Vista 20P?


 >

How do I connect devices to the Vista 20P?


 >

How do you connect a zone expander on the Vista 20P?


 >

How do I program a Vista 20P Control Panel?


 >

How many zones can the Vista 20P support?


 >

How do I add a glass break sensor to the Vista 20P?


 >

What revision chip do I need to make Vista 20P compatible with Total Connect 2.0?


 >

For how long does a VIsta 20P siren sound when it goes off?


 >

What does "exit now" message mean when I arm my security system in "stay mode"?


 >

What alarm systems are compatible with the wireless 5800Micra?


 >

How do you arm a Honeywell security system?


 >

When the alarm goes off on my Vista 20P control panel, will the system call my cell phone?


 >

Why is my Vista 20P displaying a "Check 100" message?


 >

Why does an "E8" message appear on my Vista 15P or Vista 20P Control Panel?


 >

Why won't the default installer code (4112800) let me access the programming menu on my Vista 20P Control Panel?