Home > Adams Rite Electric Strike > Options and Accessories for Electric Strikes >

Adams Rite LEK7400-09 2-1/2 Electric Strike Lip Extension, Options and Accessories for Electric Strikes
LEK7400-09 Adams Rite | JMAC Supply
 
Limited Stock
Our Price: $30.24



Product Code: ADAMS-RITE-LEK7400-09
Qty:

Description Product Resources
 

Adams Rite LEK7400-09 2-1/2 Electric Strike Lip Extension, Options and Accessories for Electric Strikes


  • Also known as: LEK740009

  • Adams Rite LEK7400-09 LIP EXTENSION KIT 7400 2-1/2 INCH

    Electric Strikes: 7100 Series Lip Extension Kits In contrast to the "typical" 1-3/4" thick door that shuts flush (or almost flush) with the jamb face, lip extensions are for center-hung doors, thick doors, or other circumstances. The last dash number, which changes the door centerline to jamb edge dimension in 1/8" increments, is specified with an electric strike. The lip extension can be added on-site for existing 7100 Series Electric Strikes by drilling or punching a small metal membrane out of the regular lip. The door centerline to jamb edge dash number on complete strike is the same as the dash number for lip extension.

    This cover plate, for use solely with Ultraline 7400 Electric Strikes, is intended to make mortising wood door pairs simpler. WDC7400 Wood Door Application

    Monitor Switches: A "monitoring" strike is needed to turn on and off any necessary visual or other signals that an operator needs in order to know what the electric strike is doing. This feature makes use of two sensor switches, one of which is triggered by the latchbolt entering the strike and the other by the device preventing the strike from being released. The interconnection of two strikes in "mantrap" or interlock scenarios, such as elevator doors, can also be accomplished with these switches. In these situations, the switch(es) of one strike govern the power to the solenoid of the other, preventing one from unlocking until the other is locked. Since every switch has both usually open and normally closed leads, it is possible to wire them to complete or interrupt a circuit.

    Power: 4603 Rectifier: Converts AC current with low voltage to DC with the same voltage. installs between the transformer and the strike in the low voltage line. form of full wave bridge. 2 amps maximum (200 PIV).

    29-0218 Piezo Horn: This device makes it possible to hear when a DC strike is powered. uses strikes of 12 VDC, 16 VDC, or 24 VDC to operate.

    Among the transformers, the 4605 changes 120 VAC to 12/24 VAC. Plenty of power for strike release is assured by the output rating of 40 Volt-amps.
    4606 Changes current from 120 VAC to 24 VAC. connects to a regular wall outlet.

    Electric strikes, magnetic locks, and other access control devices can be powered by the PS-1 Power Supply, which offers filtered and regulated voltage output. The output can be set to 12 or 24 VDC in the field. For battery backup power with 12 or 24 VDC operation, a charging circuit is built-in. Circuit board LEDs show when power is being applied.


    Technical Specifications:

    • Series: 7400 Electric Strikes


    For more information about the Adams Rite LEK7400-09, please contact us.

    Share your knowledge of this product with other customers... Be the first to write a review

    Browse for more products in the same category as this item:

    Adams Rite Electric Strike > Options and Accessories for Electric Strikes
    Adams Rite Electric Strike