|
You are here: Knowledge Base > Vista 250BPT
How do you connect the 7847i Internet Communicator to the Vista 250BPT?Last Updated: 11/07/2013 |
||
Shut off the power to the Vista 250BPT by disconnecting the AC transformer and the back-up battery. Open the 7847i's cover by pushing in the tabs located at the bottom of the device. Find the terminal strip located on the green circuit board. Terminals 3-6 on the 7847i must be connected to terminals 6-9 on the Vista 250BPT control panel. Use four-conductor wire to connect: 7847i's 3rd terminal to the Control Panel's 6th terminal. 7847i's 4th terminal to the Control Panel's 7th terminal. 7847i's 5th terminal to the Control Panel's 9th terminal. 7847i's 6th terminal to the Control Panel's 8th terminal. Now use screws and wall anchors to mount the unit. Insert an Ethernet cable into the 7847i's Ethernet port and connect the other end to your internet router. Shut the 7847i cover. Reconnect your control panel's battery power then its AC power to complete installation.
|