Seco-Larm E-960-D290Q ENFORCER Twin Photobeam Detectors with Laser Beam Alignment, 290ft (90m) Outdoors, 590ft (180m) Indoors

The SECO-LARM E-960-D290Q ENFORCER Twin Photobeam Detectors with Laser Beam Alignment does not require any wiring at all, which makes the installation, a ready-to-install wireless solution for the best in perimeter protection. Easily mounted, the sensors can be placed high enough to avoid detection of dogs or other small animals, focusing solely on people movement. The transmitter/receiver sensor package is also designed to avoid detection of small objects such as falling leaves or birds.

A typical installation arrives at a distance of 32 to 39 inches (80 to 100 cm) above the ground for most situations. The sensors are weatherproof and are housed in a sunlight-filtering case for indoor and outdoor use. It protects a perimeter up to 290 (90 m) outdoors and 590' (180 m) indoors. The four selectable beam frequencies allow for perimeter protection by eliminating crosstalk and interference between multiple units. The photoelectric beam lens can be adjusted horizontally 90 degrees, and vertically 5 degrees. This allows much flexibility in terms of how the transmitter and receiver can be mounted.

UPC: 676544000839
Also known as: SL-E960D290Q, E960D290Q

Technical Specifications: Case: PC Resin Weight: 2.47-lb (1.12kg) Operating temperature: -13º~+131º F (-25º~+55º C) Alignment angle: Horizontal (+/-)90º, Vertical: (+/-)5º Laser output power: 5mW. Laser wavelength: 650nm. Operation LED: Green LED (transmitter and receiver) ON: When power is applied. Tuning LED: Yellow LED (Receiver) ON: When alignment is successful Alarm LED: Red LED (Receiver) ON: When an alarm is initiated Tamper output: NC. switch, 1A@120VAC Alarm output: NO./NC. relay, 1A@120VAC Interrupt speed: 50msec~700msec (variable) Detection method: Simultaneous break of 2 beams Power: 10~30VAC/VDC (Non-polarized) Current: 63mA Max Range: Outdoor - 290' (90m); Indoor - 590' (180m)

For more information about the Seco-Larm E-960-D290Q, please contact us.