Muxlab 500730 6G-SDI Extender Over UTP

The 6G-SDI Extender is a unique new solution from Muxlab for extending SDI based cameras or other SDI sources up to 4K resolution up to 500 feet (150m).

Standard Cat5e/6 UTP cable is used for the extension. The pair of units (Transmitter, Receiver) use PoE for power and only require the Receiver (Rx) side to be powered. The input source for the 6G-SDI Extender is HD-SDI using four coax cables, 3G-SDI using two coax cables, and 6G-SDI using a single coax cable.

Technical Specifications: Compliance: FCC, CE, RoHS Connectors – power: One standard 2.1mm power jack Connectors (UTP): RJ45 / Ethercon, for UTP communication Connectors (control): Mini USB, for configuration and firmware updates Power: 48V external power supply with US, UK and Euro blades Connectors (sync): 2 BNC connectors Connectors (SDI out): 4 BNC connector for SDI output ( 0.8V pp, 75 ohm ) Connectors (SDI in): 4 BNC connector for SDI input ( 0.8V pp, 75 ohm ) Top panel (TX): Mini USB for firmware updates status LEDS Rear panel (TX): RJ45 for UTP cable between RX and TX unit Front panel (TX): BNC for SYNC output signal, 4x BNC SDI output connectors Rear panel (RX): +48 V power jack, BNC for SYNC input signal, RJ45 for UTP cable between RX and TX unit, 4x BNC, SDI output connectors Front panel (RX): Mini USB for firmware updates status LEDS Control: Serial console emulation with USB interface Color: Black Enclosure: Metal box, approx. 5.6”x4”x1” (RX) / 4.3” x 4.3” x 1” (TX) Environment: 6G-SDI digital signal transmission

For more information about the Muxlab 500730, please contact us.