MS Sedco CP-TX-PCB ClearPath Transmitter Circuit Board
-
MPN: CP/TX-PCB
-
JMAC ID: 200236720
The MS SEDCO CP/TX-PCB is a ClearPath wireless transmitter circuit board assembly designed for automatic pedestrian door activation systems. Supporting three selectable radio modes-HDRC, 300 MHz, and 390 MHz, the transmitter communicates with compatible MS SEDCO CP/RX receivers and supported legacy radio control equipment. The board operates from a 9-volt battery and features a 12-position DIP switch for matching transmitter and receiver security codes. Supplied as a transmitter assembly without a mounting box, the CP/TX-PCB supports replacement, repair, and integration into compatible push plate and bollard activation assemblies.
MS SEDCO CP/TX-PCB ClearPath Wireless Door Activation Transmitter Board
The MS SEDCO CP/TX-PCB ClearPath Transmitter Assembly provides wireless activation signaling for compatible automatic pedestrian door operators. Designed as a replacement or installation component for the MS SEDCO ClearPath radio control system, the transmitter sends an activation signal to a compatible receiver when connected to a momentary push plate switch. Its three selectable radio modes-High Definition Radio Control (HDRC), 300 MHz, and 390 MHz allow installers to configure the transmitter for supported ClearPath receivers and existing radio control installations. The CP/TX-PCB is supplied as a transmitter assembly without a mounting box, making it suitable for replacing a transmitter within an existing activation station or integrating wireless activation into compatible door control hardware.
The CP/TX-PCB operates using a standard 9-volt battery and incorporates a three-position frequency selector for HDRC, 300 MHz, and 390 MHz operation. Its 12-position DIP switch establishes the radio security code used to communicate with a matching receiver. The 300 MHz setting uses DIP switch positions 1 through 10, while HDRC and 390 MHz operation use all 12 positions. MS SEDCO's proprietary HDRC technology provides an additional radio mode for installations using compatible ClearPath equipment. The transmitter also incorporates SignalLock technology and integrated signal-enhancing antenna circuitry to support wireless activation communication. Manufacturer documentation identifies FCC Part 15 compliance for the ClearPath transmitter family, with operation subject to applicable radio interference requirements.
Designed for automatic pedestrian entrances, accessible door activation stations, commercial buildings, healthcare facilities, educational properties, and industrial entrances, the MS SEDCO CP/TX-PCB works with compatible CP/RX ClearPath radio receivers. The transmitter can be integrated into supported MS SEDCO push plate assemblies and 608 Series bollard activation systems where the appropriate mounting hardware is provided. Its 300 MHz mode supports compatible Multi-Code radio equipment, while the 390 MHz mode supports selected MS SEDCO and Genie radio control products using matching coding arrangements. The selectable frequency design provides a replacement option for existing wireless door activation installations without requiring the complete transmitter housing to be replaced. Compatibility depends on the receiver's operating frequency, security code format, and supported activation functions.
The MS SEDCO CP/TX-PCB is configured by selecting the required radio frequency and setting its DIP switches to match the compatible receiver. The transmitter's two-wire activation connection attaches to the common (COM) and normally open (N.O.) terminals of a compatible momentary push plate microswitch. Once the circuit board, battery, and activation switch are properly installed, pressing the switch causes the transmitter to send a wireless activation command to the connected receiver. The board-only configuration does not include a complete wall-mounted activation station, push plate, or receiver. MS SEDCO recommends installation and maintenance by qualified automatic door technicians, with final testing performed according to the door operator manufacturer's instructions and applicable ANSI/BHMA automatic door safety standards. The manufacturer's August 2024 documentation specifies a three-year warranty against manufacturing defects from the date of factory shipment, subject to its warranty terms.
UPC: 999999417397
Also known as: M6-CPTXPCB, CPTXPCB
For more information about the MS Sedco CP/TX-PCB, please contact us.