Bosch MX934i Multiplex PIR Intrusion Motion Detector

The wall mount MX934i PIR Intrusion Detector uses Motion Analyzer II signal processing to reduce false alarms. Alarm and tamper conditions are transmitted to the control panel through the two-wire multiplex bus. The detectors replaceable and pointable mirrors, three coverage patterns, and three mounting options provide installation flexibility.

UPC: 782695077771
Also known as: DS-MX934I

Technical Specifications: Standby Power: There is no internal standby battery. Connect to DC power sources capable of supplying standby power if primary power fails. For each hour of standby time needed, 0.4 mAh are required. For UL Listed Requirements, four hours (1.4 mAh) minimum are required. Input (Voltage): Connects directly to the multiplex (MUX) bus of the control panel and optionally to an auxiliary 12 VDC source Current Draw (four-wire): LED off: <0.4 mA draw on MUX bus 0 mA draw on Aux. power LED on: <0.4 mA draw on MUX bus 3 mA draw on Aux. power Current Draw (two-wire): LED off: <0.4 mA draw on MUX bus LED on: 2 mA draw on MUX bus Tamper: A tamper condition is signaled through the multiplex bus and displays at the keypads. Alarm: Signals through the multiplex bus Internal Pointability: Coverage is adjustable ±10° horizontally, +1° to -18° vertically. Location: Surface or corner mount. Ceiling mount with the appropriate mounting bracket. Height (recommended): 2 m to 2.6 m (6.5 ft to 8.5 ft) Radio Frequency Interference (RFI) Immunity: No alarm or setup on critical frequencies in the range from 26 MHz to 950 MHz at 50 V/m. Temperature (Operating): -29°C to +49°C (-20°F to +120°F) For UL Listed Applications, 0°C to + 49°C (+32°F to +120°F) Dimensions: 10.8 cm x 7 cm x 4.6 cm (4.25 in. x 2.75 in. x 1.8 in.)

For more information about the Bosch Security MX934I, please contact us.