Knowledge Base:  

How do I program my Lockey E-Remote?


Last Updated: 12/16/2013
By

Follow these instructions to add an E-Remote to your E-Digital Electronic Lock.

1. Enter the programming code into the keypad of your E-Digital Lock. (The default code is "0000".)
2. Press the E-Digital Button.
3. Press (1), then (0).
4. Press the E-Digital Button.
5. Push down a button on the E-Remote.
6. After 8 seconds, your Lockey E-Remote should be operational.

You will hear 3 short warning sounds if you try to add the same remote twice. E-Digital Locks, like the E-985R Lever Lock, can support up to 5 remotes.


Similar Products:
E-930R Electronic Knob Lock
E-910R Electronic Deadbolt


Was this article helpful?

Comments:
 

Related Articles
 >

How do I change the battery for my E-Digital Lock remote?