Knowledge Base:  

How do I install the E985-R mounting plate?


Last Updated: 12/13/2013
By

Follow these steps to install the E-985R Electronic Lever Lock mounting plate.

1. Thread the IC wire through the mounting plate hole. (Be careful not to pinch the wire)
2. Insert two screws to hold mounting plate in place.
3. Check to make sure the lock assembly is tight. If not, loosen screws, adjust plate position, and tighten.


Similar Products:
E-930R Electronic Knob Lock
E-910 Electronic Deadbolt
E-PRO-R Lever Lock


Was this article helpful?

Comments:
 

Related Articles
 >

Where should I store the override key for my E985-R Electronic Lever Lock?


 >

How do I install the receiver module for the E985-R Electronic Lever Lock?


 >

How do I change the lever handling on my E985-R Lever Lock?


 >

What is the "E-Digital" button on my E985-R keypad used for?


 >

How do I set the autolock time delay function on the E985-R Lever Lock?


 >

How do I program a disposable user code into the E985-R Lever Lock?


 >

If you delete all user codes from the E985-R, will the door still lock?


 >

How do you disable all user codes on the E985-R Lever Lock?


 >

What is the programming code for my Lockey E985-R Lever Lock?


 >

What do the different light indicators mean on my E985-R Lever Lock?


 >

Is there a way to restore the E985-R Lever Lock back to its factory settings?


 >

Can you mute sounds on the E985-R Lever Lock?


 >

Does the E985-R glow in the dark?