Linear EXA-1000 Omni-Directional Remote Antenna

The Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linears receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam.

NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be.

The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.

UPC: 93863110870
Also known as: LN-AAE00198, EXA1000

Technical Specifications: LED Indicator Steady: Indicates "learn" mode; Flashing: Indicates number of transmitters learned on the selected channel; RF Activity: Blinks synchronously with detected RF activity Dimensions: 3” W x 19.5” H x 6” D Regulatory Requirements: FCC and DOC Accessories: Mounting bracket, screws, and anchors (supplied) Connectors: Screw terminal,+,-, with N/O, N/C, and common per receiver channel Current: 25 mA at standby at 12 VDC; 60 mA in alarm at 12 VDC, DXR-701; 90 mA in alarm at 12 VDC, DXR-702 Operating Voltage: 11 to 17.5 VDC 12 to 16 VAC Input Impedance: 75 Ohm - 2:1 VSWR Antenna DXR-701: Wire lead; DXR-702: F-connector with antenna (supplied) Clear Low Battery: Press and release mode switch on channel 2 (DXR-702 only) to clear low battery Clear Latch: Press and release Erase Memory: Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel Transmitters Learned: Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel Learn Mode: Press and release to enter learn mode Mode Button (one per channel): Field Selectable Receiver Output Modes: Momentary, four seconds (factory set), Momentary, one second, Flip-flop toggle latch, 2-Channel Number of Stored Transmitter Codes: 32 per receiver Sensitivity: -95 dBm (typical) Operating Temperature: 32° to 140° F (0° to 60° C) Measure Range: 700 feet in one quadrant with DXT-21 transmitter; 500 feet in open air (four quadrant test) Number of Channels: DXR-701, one channel, DXR-702, two channels Number of Codes: 1,048,575 Data Format: DX format Operating Frequency: 315 MHz

For more information about the Linear EXA-1000, please contact us.