Knowledge Base:  
You are here:Knowledge Base > Questions By Product > IS216

Page of 1

How do I wire an IS216 motion detector to my Vista Control Panel?

By Petra Paulson To install the IS216 motion detector you must create a four-wire connection from the detector to your Honeywell Vista Control Panel . Use the first two wires to connect terminals +/-

What do the IS216 motion detector DIP switches control?

By Petra Paulson On the motion detector's circuit board, Switch 1 controls the LED light and Switch 2 controls device sensitivity. (This applies to the Honeywell IS215T as well) Switch 1 is commonly