Knowledge Base:  

Can you mute sounds on the E985-R Lever Lock?


Last Updated: 12/13/2013
By

Yes, the E985-R can be programmed to mute sounds...but not all sounds.


In "mute mode", pressing keypad buttons and operating/programming errors will still be accompanied by a beeping sound. However, the warning alarm on the device will be deactivated. For this reason, Lockey recommends muting the lock only when it's completely necessary. Indicator lights will continue to function normally when the lock is muted.


To mute the E985-R, follow these steps:
1. Enter your programming code. The default code is "0000". If you forget your programming code, you will have to restore your device to its factory settings.
To restore: Press and hold the "R" button for 5 seconds on the inside of the lock's receiver module. Doing so will revert your lock back to its default programming code of "0000" (and a default user code of "1234").
2. Press the E-Digital Button.
3. Press (8).
4. Finally, press the E-Digital Button to save your programming changes.

Your locked is now muted. To disable the mute function, simply repeat the steps above.


Similar Products:
E-930R Electronic Knob Lock
Lockey E-Remote


Was this article helpful?

Comments:
 

Related Articles
 >

Where should I store the override key for my E985-R Electronic Lever Lock?


 >

How do I install the E985-R mounting plate?


 >

How do I install the receiver module for the E985-R Electronic Lever Lock?


 >

How do I change the lever handling on my E985-R Lever Lock?


 >

What is the "E-Digital" button on my E985-R keypad used for?


 >

How do I set the autolock time delay function on the E985-R Lever Lock?


 >

How do I program a disposable user code into the E985-R Lever Lock?


 >

If you delete all user codes from the E985-R, will the door still lock?


 >

How do you disable all user codes on the E985-R Lever Lock?


 >

What is the programming code for my Lockey E985-R Lever Lock?


 >

What do the different light indicators mean on my E985-R Lever Lock?


 >

Is there a way to restore the E985-R Lever Lock back to its factory settings?


 >

Does the E985-R glow in the dark?