 |
 |
 |
|
System Sensor 2WTR-B Photoelectric i3 Smoke Detector, 2-Wire, Thermal Sensor, Form C Relay
Also known as: 2WTRB, BK-2WTRB
The 2WTR-B is a 2-wire, photoelectric i3 smoke detector with thermal sensor and Form C relay. Throughout the i3 series, installation is simple with its installer-friendly base and plug-in design. The base accommodates a broad range of back box and direct mounting options and provides ample space for pre-wiring the device. To complete the installation, the i3 detector plugs into its base with a simple Stop-Drop N Lock action.
To reduce the likelihood of nuisance alarms, all i3 detectors are equipped with both drift compensation and smoothing algorithms. These capabilities minimize both short- and long-term causes of nuisance alarms, such as RF interference and dust accumulation. When connected to the 2W-MOD2 loop test/ maintenance module or an i3 Ready panel, 2wire i3 detectors can generate a remote maintenance signal when in a maintenance or freeze trouble condition. To measure the sensitivity of any i3 detector, the SENS-RDR displays the reading, in terms of percent-per-foot obscuration, within seconds.
i3 has red and green LEDs to simplify local status indication during power-up, standby, alarm, maintenance, and freeze trouble conditions. When in alarm, i3 sounder models generate an 85 dB temporal tone. If connected to the RRS-MOD reversing relay/synchronization module, all i3 sounders on the loop will activate when one detector is in alarm. The RRS-MOD also synchronizes i3 sounder output to ensure a clear audible signal.
Should the application call for differentiating between a local and a general alarm, the i3 line offers an isolated thermal model, which initiates a local alarm when smoke is detected, and a general alarm when the thermal sensor is activated. |
Features:
- 85 dB sounder
- Form C relay
- Isolated thermal sensor
- Plug-in design (base included)
- In-line terminals
- Flexible mounting options
- Stop-Drop N Lock attachment to the base
- Removable cover and chamber
- Remote maintenance signaling
- Drift compensation and smoothing algorithms
- Simplified sensitivity measurement
- Dual-color LEDs
|
Technical Specifications:
- Alarm Current: 130mA max., limited by panel
- Auxiliary Contact: Form C
- Auxiliary Contact Ratings: 2A @ 30V AC/DC
- Detection: Photoelectric
- Dimensions: 2.0" (51mm) H x 5.3" (127mm) Dia.
- Freeze Trouble: 41F (5C)
- Heat Sensor: 135F (57.2C) fixed
- Humidity Range: 0% to 95% RH, noncondensing
- Maximum Ripple Voltage: 30% of applied voltage (peak to peak)
- Operating Voltage: 12/24 V non-polarized nominal, 8.5 min. to 35 max.
- Sensitivity: 2.5%/ft. nominal
- Standby Current: 50 A max. avg., 100 A peak
- Temperature Range: 32 to 100F (0 to 37.8C)
- Weight: 7.1 oz. (200 g)
- Wiring: 2-wire
- Wiring Gauge: 14-22 AWG
|
UPC: 783863019975
Average rating: 5.0, based on
1 review
For more information about the System Sensor 2WTR-B, please contact us.
|
|
|
 |
|
 |
|
