Knowledge Base:  
You are here: Knowledge Base > Lockey 2835

How do I change the code on my 2835 keyless lever lock?


Last Updated: 12/11/2013
By

Follow the instructions below to change the user code on your Lockey 2835MG Keyless Lever Lock.

Press and hold the "C" button to start programming your lock. Change the user code by using tweezers to manually remove the code (red) and non-code (blue) tumblers. You can program codes from 3-7 digits long. Remove blue tumblers and add red to increase the digits in the code. Remove red tumblers and add blue tumblers to decrease code digits.

Once the new code is programmed, replace the lock plate and test the code. If the code works, then your lock is ready to be installed on the door.


Was this article helpful?

Comments:
 

Related Articles
 >

How do I disable the passage function on my 2835DC Lever Handle?


 >

How do I change the code on my 2835 Lever Lock?


 >

Is the Lockey 2835MG good for janitor or custodial closets?


 >

How do I enable the passage function on my 2835 Lever Lock?


 >

What does it mean if my 2835 Lever Lock has changeable handling?