|
|
You are here: Knowledge Base > Lockey M210
How do I adjust the backset on the Lockey M-210 Deadbolt?Last Updated: 12/12/2013 |
||
|
By Petra Paulson
2. Slide the interslide to the back of the deadbolt. This will move the slotted hole to the 2 3/4" setting. Note: 2 3/8" is the default factory setting. Move a wood drill up and down inside the 7/8" mortise hole to enlarge it. This gives the "CAM" room to move. Also, make sure to drill a hole in the door frame that can accommodate the 1" throw. Similar Products: M-213 SN Spring Latch
|