Home > Napco >

Napco C-100STE Dual Technology Microwave/PIR Detector
C100STE Napco | JMAC Supply
 
Our Price: $31.82



Product Code: NAPCO-C-100STE
Discontinued, Call For Replacement

Description
 

Napco C-100STE Dual Technology Microwave/PIR Detector


Upon installation, a NAPCO Adaptive Microwave/PIR Detector powers up, initialized in the first of its 12 senstivity modes, i.e., the most sensitive, enabling it to sample prevailing environmental conditions. Faced with hostility or tranquility, the Adaptive detector automatically selects the most appropriate detection mode accordingly, optimizing both intruder catch and stability. Each time the sensors detect a stimulus stong enough to generate a signal, but insufficient in strength to indicate an alarm, the detector will automatically change sensitivity modes, effectively widening the gap between the detected signal and its alarm threshold. Therefore, environmental disturbances, those that register by the PIR and/or microwave sensor, are better tolerated and the threat of false alarms or nuisance alarms is dramatically reduced, far surpassing the performance of conventional dual technology devices. And, because a dynamic Adaptive Detector literally adjusts to its surroundings minute-by-minute, once disturbances quiet, e.g., the space heater turns off again, the air conditioner stops blowing the blinds, power stops browning-out, animals vacate the intelligent detector again escalates its sensitivity, mode by mode so the premises always enjoys the greatest level of fast intruder-catch detection and false alarm protection possible.

The Napco Adaptive Sensor is the most forgiving sensor available because it is so smart and makes the sensitivity and critical range adjustments an experienced alarm professional would, if one were standing by, 24-hours a day, seven days a week to make them. Any activity beyond the units protected area, detected by the microwave section is also automatically compensated for. The unit even actively tests both its channels (PIR and Microwave), regulary activating each, to make sure it is onthe-job, performing to specification. An absolute solution to false alarms, callbacks and service calls NAPCO Adaptive Detectors pay for themselves in the time and money they save.
Features:
  • Dual Technology Microwave/PIR Detector
  • Microprocessor signal processing.
  • Power-up system diagnostic tests virtually all electronics.
  • Microwave and PIR self test.
  • Watchdog microprocessor supervision.
  • Microwave circuit supervision.
  • 4-Pulse Mode for hostile environments.
  • Quick-Response Mode while disarmed.
  • Trouble Output.
  • Automatic PIR operation on microwave failure.
  • Dual-element PIR sensor
  • High-efficiency, dirt-resistant grooves-in lens.
  • Extensive RFI and EMI filtering ensure optimum immunity to false alarms.
  • Large lens area assures high PIR sensitivity.
  • Horizontal as well as vertical aiming capabilities.
  • Selectable Microwave/PIR LED indication visible from virtually any angle, extinguishable after testing.
  • Small size; modern, unobtrusive design..
  • Silent operation
  • Bracket-free corner or wall mountable.
  • Universal Swivel Bracket Kit available.


Technical Specifications:

  • General Coverage with standard wide-angle lens, measured indoors at 20 C (68 F), typical: 30'x35'
  • Operating Temperature: -10 to +50 C (14 to 122 F)
  • Mounting: Wall or corner, 6 to 10 max.
  • Output Relay: Form A, Normally-Closed;
  • Relay Time: Approximately 4 seconds
  • Contact Ratings: 100mA, 24Vdc with internal 10 current-limiting resistor
  • Trouble: Open collector current sinking with 39 current-limiting resistor, 20mA max.
  • Status Input: Panel disarmed, >5V; armed, <1.5V.
  • Self-Test Interval: 11-16 hours.
  • Power-Supply Requirements: Note: This unit is intended for operation from a power source that provides battery backup in the event of a power failure.
  • Filtered DC: 12Vdc
  • Current Drain at 12Vdc: Idle, 33mA; Alarm, 35mA
  • Microwave Frequency: X Band
  • Physical Dimensions: 4.5" x 2.5" x 1.7" (HxWxD) (11.4cm x 6.4cm x 4.3cm)
  • Shipping Weight: 7 oz.


UPC: 785026000547

Average rating: 5.0, based on 2 reviews


For more information about the Napco C100STE, please contact us.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Napco